Buyer's Guides & Shop Know-How
Technical guides written for the job site, not the showroom - how to choose the gear, how to run it, and how to fix it when the cut goes wrong.
Maintenance & TroubleshootingMIG ConsumablesHow to Replace a MIG Liner: Steel vs PTFE, Measuring and Trimming, Step by Step
Steel or PTFE, how to measure and trim a MIG liner, and how to replace it step by step, with the signs...
Maintenance & TroubleshootingMIG ConsumablesMIG Welder Birdnesting and Burnback: Causes and Fixes for Drive Rolls, Liners and Tips
Why MIG wire tangles at the drive rolls or welds itself to the contact tip, how to tell which part is causing...
Buying GuideMaintenance & TroubleshootingMIG Contact Tip and Nozzle Compatibility Guide: Threaded vs Non-Threaded
Contact tips, gas diffusers, insulators and nozzles only work as a matched set. Learn threaded vs non-threaded tips, thread-on vs slip-on nozzles,...
Maintenance & TroubleshootingPlasma CuttingPlasma Cutter Troubleshooting: Bad Cuts, Dross, and Lost Arc
Quick answer: Almost every plasma cutting problem — can’t cut through, dross-covered edges, a lost arc, or fast-wearing consumables — comes down...
Not covered here?
Describe the material, the thickness and the process. You get an answer from the counter, not a ticket number.
Ask the counter